Publicité
Les langues disponibles
Les langues disponibles
4 - Installing your wine cabinet
- When you receive your cabinet, make sure when you unpack it there is no defect in its external appearance (from shocks, deformation,
etc.).
- Open the door and check to see that the inside is complete (walls, shelfs, hinges, control panel, etc.).
- With the 056 table-top model, if you wish to install your cabinet under a worktop, you will need to remove the top plate which is fixed from
underneath by two front screws in the hinges and two screws behind in the angle brackets. Keep the two front screws if you wish to encase
the unit under a worktop so as to fix it to the existing worktop (see diagrams Page 6).
If you need to adjust the height of the cabinet, this can be done using the hexagonal extenders included in the accessories pack (see dia-
gram below).
Extender
Foot
- Now carry the cabinet to where you want to install it. Make sure the place selected is:
- away from any source of heat
- not too damp (laundry room, utility room, bathroom, etc.)
- on a stable level surface
- equipped with a power point (standard socket, 230V/115V, 50/60Hz, 16A, connected to earth)
- Make sure the On/Off switch (I/O) located on the right of the control panel is in the Off position (O).
- Take out the mains lead and connect it as shown in Section 3. Check the power point supply (fuses in, fuse amperage, circuit breaker wor-
king. You can if you wish use another appliance to check the power supply.)
1
- Tilt the cabinet forwards. Make sure the door is locked to prevent
it from opening.
2
- Unscrew the back feet and fit the extenders, using a 17 mm span-
ner or an adjustable spanner.
3
- Screw the 2 rear feet back on under the extenders.
4
- Proceed as above for the 2 front feet. This time, make sure you tilt
the cabinet backwards.
- 5 -
Publicité
