Publicité
Les langues disponibles
Les langues disponibles
- Adjust the four feet underneath the cabinet (screwing them up or unscrewing them) so that your cabinet is level (it is advisable to use a spi-
rit level).
- Slide the cabinet into its final position, leaving a space of between 2 and 6 cm between the wall and the rear wall of the cabinet. For instal-
lation under a worktop (Model 056), fix the cabinet to the worktop using two screws in the top hinges (see diagram below).
- Do not obstruct the front ventilation grille (ch. 1 N¡. 7)
- Make a ventilation hole (flush-mounted grille) in the worktop (see diagram 4 below)
- Remove the protective materials from the inside of the cabinet.
- Remove the protective paper from the charcoal filter that you will find in the accessories pack. From inside the cabinet, position the filter in
the ventilation hole located in the top left of the cabinet.
- Arrange the shelfs to suit your convenience (see Section 6).
- Wait 48 hours before switching the cabinet on so as to allow the fluids to settle.
NB: If ever you need to move the cabinet, do not tilt it at an angle of more than 45¡, and always on the side where the lead comes
out.
056: Installation Diagram
1- Remove the plate by unscrewing
the 2 screws located under the 2
hinges (door open) and the 2 screws
behind in the angle brackets.
Plate
Hinge
2- Adjust the 4
3- Slide the cabinet into its final posi-
feet.
tion.
- 6 -
4- Screw the 2 screws through the
hinges and into the worktop.
Ventilation Hole
(grille, etc.)
Publicité
