Publicité
Les langues disponibles
Les langues disponibles
3 - INSTALLING YOUR WINE CABINET
FREE STANDING
When unpacking your cabinet, ensure that it does not show any signs
of impact, buckling or other damage. Carefully remove all of your wine
cabinet's protective elements and adhesives.
Open the door and check that the various elements are intact.
Arrange the power cable so that it does not come into contact with any
of the cabinet's components.
Transport your cabinet to its intended location.
WAIT 48 HOURS BEFORE PLUGGING IN YOUR APPLIANCE Whenever
moving your cabinet, never tilt it more than 45°, and always
on its side, on the side of the power cable.
If fitting your wine cabinet inside a
unit:
Ensure that the base of the unit is very stable to avoid damaging the
appliance. Ensure that the appliance is well ventilated by observing the
dimensions on the diagram. It is essential to have a vent at the back of the
appliance. If another unit is going to be placed on top of the cabinet,
ensure that the vent extends to the top.
1- Adjusting the feet:
Fully tighten the 2 back feet, as previously indicated. Pre-setting the front
feet: screw or unscrew the front feet in order to level the appliance (see
diagram B).
2 - Installing the upper fixing plate:
Remove the 2 black plastic seals. Position and fasten the plate using the 2
MSXIS screws. Remove the hinge cover.
Rear metal part in contact with
the wall or unit
EN
-4-
Back feet
A
HORIZONTAL SURFACE
RECOMMANDATION
The place where you install the cabinet must:
- be open and well ventilated (not enclosed in a cupboard, for example),
- allow for a minimum gap of 10 cm between the wall and the back
of the cabinet,
- not be close to any source of heat,
- not be too damp (utility room, laundry room, bathroom...),
- have a stable, flat floor,
- have a standard accessible power supply (socket that complies with the
standards of the country, earthed with circuit breaker).
3 - Positioning the appliance inside the unit:
Position the appliance inside the unit, against the right side if the appliance
has a left-hand door and against the left side if the appliance has a
right-hand door.
Ensure that the appliance is completely stable by checking that the 2 front
feet are in contact with the surface of the unit, in order to prevent any
buckling of the appliance's body once loaded. If this is not the case, screw
or unscrew the front feet until they are fully in contact with the unit base.
The appliance must be positioned so that its front is a maximum of 8 mm
from the front of the unit. The cabinet must then be secured using the
upper fixing plate (2countersunk screws).
SIDE VIEW
Back feet
B
Publicité
