Publicité
Les langues disponibles
Les langues disponibles
5 - I
II - Fitting the handle
Instructions :
1 - Insert 1 washer onto 1 screw
2 - Insert the screw into the hole provided for this effect in the
wine cabinet door, from the inside of the door towards the
outside
3 - With a screwdriver, carefully screw and tighten the screw in the
handle stud
4 - Repeat the operation for the other handle stud
6 - L
Your EuroCave cabinet has been designed to be evolutionary. Depending on the model, it enables you to adapt it to your needs, and evolve in terms of storage:
I - Recommendations on your wine cabinet layout
Your EuroCave wine cabinet has been designed to hold a maximum number of bottles in complete safety. We recommend that you abide by the following
suggestions in order to optimise its storage capacity.
- Please distribute your bottles as evenly as possible on the various shelves in your cabinet, in order that the weight is distributed over a wider area. Also
make sure that bottles do not touch the back or the walls of the cabinet.
- Please distribute bottles as evenly as possible over all of the upper area of the wine cabinet (try not to put all your bottles either at the top, or at the
bottom).
- Be sure to follow the storage recommendations according to the type of storage shelves in your cabinet, and never pile bottles on top of each other on
a sliding shelf.
- If you are equipped with sliding shelves, it is preferable to place these at the top of the cabinet for ease of daily access.
- For the same reason, place one or two bottles of each of your various wines on the sliding shelves and keep your reserve bottles on the storage shelves.
You then only have restock the top shelves as you drink a bottle.
- When using your wine cabinet, never pull out more than one sliding shelf at a time.
II - Adding sliding shelves
When purchasing your cabinet, the sliding shelves are adjusted to perfectly suit the internal dimensions of your apparatus. If under any circumstances, a shelf
is too wide or too narrow, you may be required to perform this adjustment. In order to achieve this, unscrew the screws from the right or left slide (2
screws) and position the slide at the desired width and reattach the screws. Repeat the operation for the second slide (if required):
Slider
8
NSTALLING YOUR WINE CABINET
– S
AYOUT
Slider
TORAGE
Slider
Adjusting screws
Publicité
