Viper AS5160T Mode D'emploi page 13

QUICK START GUIDE
Battery charger setting (for disc machines with on-board battery charger)
6. Remove the screws (A, B, C, D, Figure 4.1).
7. Open the charger and find the sw1 (E, Figure 4.1).
8. Set the switches as the table of (Figure 4.1).
9. Install the screws (A, B, C, D, Figure 4.1) after setting complete.
ACCORDING TO THE TYPE OF BATTERIES (WET OR GEL / AGM), SET THE MACHINE AS FOL-
LOWS: (only for orbital machine)
NOTE
Regarding the factory setting, learn the bat-
tery type from boot time display according
to above table
1. Press both the buttons (A, Figure. 4) and (B) at the same
time, Insert the ignition key (D) and turn on the power,
after 0.5 second, enter battery setting mode. LED dis-
play during setting (C), Release the buttons.
2. The mode can be shift from 0 to 5 by pressing button
(B), or shift from 5 to 0 by pressing button (A). After the
battery mode setting is completed, turn off the power (D)
and the new setting of battery mode can be saved auto-
matically.
3. The battery type setting is completed.
Mode Battery type/Battery
manufacturer
0 WET
1 GEL/AGM
2 DISCOVER
3 OPTIMA
4 EXIDE
5 FULLRIVER
Battery charging
curve
General WET curve
General GEL/AGM
curve
DISCOVER EV GEL
OPTIMA GEL
EXIDE GEL
FULLRIVER GEL
10
LED2
LED1
D
Figure 4.2
LED display during
setting (
C, Figure. 4.2
ENGLISH
LED3
C
B
A
Boot time display
)
LED1 blink
twice
LED2 blink
twice
LED3 blink
twice
Both LED1 and
LED2 blink
twice
Both LED1 and
LED3 blink
twice
Both LED2 and
LED3 blink
twice