KTM A46014986033 Instructions De Montage page 36

6 CONNECTIVITY UNIT OFFROAD
6.1
Connectivity Unit Offroad
GPS unit
The app provided by the manufacturer guides you through the operation of the Connectivity Unit Offroad.
Possible states
•
Button
•
Button
•
Button
settings.
•
Button
•
Button
is not changed, all indicator lamps go out.
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
tooth
•
Indicator lamp
•
Indicator lamp
•
Indicator lamp
14
Connectivity Unit Offroad (CUO)
1
is attached on the right fork leg.
2
is mounted on the fender.
3 is pressed briefly (<1.5 s) – A recording is started or stopped.
is pressed and held (1.5 s... 6 s) – The pairing process is started.
3
is pressed and held (6 s... 12 s) – The Connectivity Unit Offroad is prepared for reset to factory
3
3 is pressed and held (12 s... 18 s) – The Connectivity Unit Offroad is reset to factory settings.
is pressed and held (>18 s) – All processes are aborted, the Connectivity Unit Offroad condition
3
A does not light up – The Connectivity Unit Offroad is switched off.
A lights up blue – The Connectivity Unit is ready for operation.
flashes blue – A recording is downloaded.
A
flashes green – A recording is active.
A
A flashes yellow – A recording was started before the position was captured via GPS.
does not light up – The Bluetooth
B
lights up blue – Bluetooth
B
B flashes blue – The pairing procedure via Bluetooth
lights up green – The Connectivity Unit Offroad is connected to an end device via Blue-
B
® .
does not light up – The WiFi module is switched off.
C
C lights up blue – The WiFi module is active but not connected.
lights up green – The WiFi module is active and connected.
C
® module is switched off.
® is active and no end device is stored.
® has been started.
M02091-10