Publicité
Les langues disponibles
Les langues disponibles
Connecting (Cabling) Each PVP
Connecting Power
The following sections provide information and diagrams on connecting signal and power
between panels. To preserve the IP65 rating, always cover all open connectors with the
and Signal Cables
preinstalled IP-rated covers.
Refer to the
Introduction
or
Operation
sections in this User Manual for available cables
and item numbers.
Connecting
Signal cable panel connections can use several different configurations. The basic
configuration to connect the signal from one panel to the next is as follows.
the Signal Between
1. The source signal is connected to the first panel.
Joined Panels
2. A signal cable is then connected from the first panel.
3. The connections continue to daisy-chain until all panels are connected.
4. The route of the cables used to make the signal connections can vary.
The following diagrams are recommended suggestions for signal connections between
panels.
This diagram shows an example of a simple signal connection.
Signal Jumper Cable
DVI or
HDMI
May be used to run
Video Signal Cable
a backup line to the
in from VIP Driver
VIP Driver
max. cable length
100 m/328 ft
To preserve the IP65 rating, all open power and data connections on the panel
must be covered with the attached IP rated covers.
PVP X6IP User Manual, Rev. 7
19
Publicité
