RECORD SETUP
RECORD SETUP
RECORD CONFIGURATION
SCHEDULE SETUP
HOLIDAY SETUP
SELECT MENU: ▲▼, & [ ENTER ]
RECORD CONFIGURATION
RECORD CONFIGURATION
OVERWRITE
MULTIPLEX
QUALITY
RESOLUTION
100 IPS@720@288
RECORD IN ALARM
RECORD IN MOTION
CONTINUOUS RECORD
SELECT : ▲▼ , CHANGE VALUE : + -
OVERWRITE
As opposed to an analogue tape recorder, the digital recorder has no tape to rewind when it is full. The
digital recorder has a so-called FIFO (first in first out) memory. The oldest data is overwritten by new data, so
that the latest events (depending on the memory capacity) are always present on the hard disk.
ON: Old data is automatically overwritten by new data when the hard disk is full.
.
OFF: When the card memory limit is reached, recording automatically stops.
You now have to delete the data on the hard disk manually to make another recording.
MULTIPLEX
Under this menu item, you can activate/deactivate recording during playback.
DUPLEX: Recording during playback is not possible (Internet access is possible
TRIPLEX: Recording during playback is possible (Internet access is possible).
Important: In TRIPLEX mode, the playback and recording speeds are halved.
QUALITY
Use the + and – keys to adjust the picture quality.
The following settings are possible: BASIC / NORMAL / ENHANCED / FINE / SUPER FINE
RESOLUTION
Use the + and – keys to adjust the resolution.
The following settings are possible: 200IPS@360x288 (200 frames/sec.)
ALARM / MOTION / CONTINUOUS
Use the + and – keys to adjust the recording speed.
The following settings are possible: 1/1X, 1/2X , 1/3X , .........1/999X
Press the direction keys
position.
Confirm your selection with Enter
submenu.
To exit a menu item, press the menu key (15).
Press the direction keys
ON
position.
DUPLEX
SUPER FINE
Use the – and + keys to change the values of the selected
menu item.
1 / 1X
To exit a menu item, press the menu key (15).
1 / 1X
1 / 1X
100IPS@720x288 (100 frames/sec.)
(2 and 5) to change the cursor
▲▼
(2 and 5) to change the cursor
▲▼
24
(3) to open another
.
).