Sony TRINITRON PVM-1390 Mode D'emploi page 9

Pin assignment
CMPTR connector (25-pin)
meern S HS sar Fe PEUR: CRE = res 7 —? REGLES EME TR CERRE]
Fe
HE P
Rie e S
á EERIE
ERRATE
sre
aos clack. "High de 6 V): IBM nods
Low state: 3 Bit TTL p
Audio select High state (5 V or open): Audio inputs from pin 13.
Low state (less than 0.4 V}: Audio inputs from the LINE A/LINE B AUDIO IN jacks
. or VTR connector
H. sync or composite sync Negative polarity
When the high state is selected at pin 9: 1 Vp-p, 75-ohm terminated
When the low state is selected at pin 9: TTL level
"Blue Input Positive polarity
When the high state is selected at pin 9:
Analog signal {0.7 Vp-p, 75-ohm terminated, non sync ;
1 Vp-p, 75-ohm terminated, with sync on G-signal)
KON When the low state is selected at pin S
Digital signal (TTL level)
Er SN NE
= Analog/digital mode select | High state (open): Analog signal (0.7 Vp-p)
Low state (ground): Digital signal (TTL level)
High state (6 V or open): RGB Inputs from a microcomputer
Low state (ground): Separate video inputs from the LINE B S VIDEO IN
connector, or composite video inputs from the LINE A VIDEO IN or LINE B
VTR connector
During the low state, the video signal from the microcomputer is blanked and
11 V.sync Negative polarity
TTL level
12 Blanking High state (5 V or open): Video inputs from a microcomputer only
Low state (ground): Video Inputs from the LINE A VIDEO IN or LINE B S VIDEO
_IN/VTR connector
the composite video signal from the LINE A VIDEO IN or LINE B S VIDEO
IN/VTR connector is superimposed over the signal from the microcomputer.
[18 | Audio input Input level —5 dB (100% modulation), Input impedance more than 47 k ohms
14
1524
25 IBM luminance signal Positive polarity
When the high state is selected at pin 1: TTL level
When the low state is selected at pin 1: Low state (ground)
Design and specifications subject to change without notice.