SCS Sentinel SG3 Notice D'utilisation Et D'installation page 35

Open partially
8 (pedestrian
opening)
9 Pre-Flashing
Over current
A
reverse setting
Full open remote
switch
C
(on the remote
control)
Pedestrian open
remote switch
E
(on the remote
control)
External device
control function
F
key
8-1 3 seconds
8-2 6 seconds
8-3 9 seconds
8-4 12 seconds
8-5 15 seconds
8-6 18 seconds
The flashing light
9-0 blinks when the
gate starts to move
The flashing light
blinks 3 seconds
9-1
before the gate
starts to move
A-0 Stop
A-1 Reverse 1 second
A-2 Reverse 3 seconds
A-3 Reverse to the end
C-1 The top left button
C-2 The top right button
The bottom left
C-3
button
The bottom right
C-4
button
No function in
E-0
transmitter
E-1 The top left button
E-2 The top right button
The bottom left
E-3
button
The bottom right
E-3
button
No function in
F-0
transmitter
F-1 The top left button
F-2 The top right button
The bottom left
F-3
button
The bottom right
F-4
button
This function can adjust the time of
opening partially.
The factory setting is « 8-2 »
The factory setting is « 9-0 »
The factory setting is « A-3 » .
The reverse function only operates 3
times and then stops.
If gate reverses, the auto close
function will be cancelled.
The factory setting is « C-1 » .
The factory setting is « E-2 »
The factory setting is « F-3 »
EN 35