Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your refrigerator into its final location, it is important to make sure
you have the proper electrical connection.
RECOMMENDED EARTHING METHOD
A 220~240 Volt /50 Hz AC only 10 ampere fused and properly earthed electrical
supply is required. It is recommended that a separate circuit serving only this appliance
be provided.Use areceptacle which cannot be turned off with a switch or pull chain.
Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb,
turn the refrigerator control to OFF and then disconnect the refrigerator from the electr-
ical source. When you are finished, connect the refrigerator to the electrical source and
reset the control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may not close or seal
properly, causing cooling, frost, or moisture problems. It is very important of the refriger-
ator to be level in order to function properly.
To level your refrigerator, you may either turn the level leg clockwise to raise that
side to the refrigerator or turn counter – clockwise to lower that side.
NOTE: Having someone push against the top of the refrigerator take some weight off
the leveling leg. This makes it easier to adjust the leveling leg.
- 33 -
Publicité
