Publicité
Les langues disponibles
Les langues disponibles
BEFORE USE
1. Before using this product, read the owner's
manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use.
2. Perform the air purge procedure. (See previous
instructions for system purge procedure.)
3. Pour a teaspoon of good quality, air tool lubricant
into the air supply inlet of the lift control valve. (See
illustration) Connect to air supply and operate for 3
seconds to evenly distribute lubricant.
4. Check to ensure that jack rolls freely (if so
equipped with wheels) and that the pump operates
smoothly before putting into service. Replace worn
or damaged parts and assemblies with manufacturer
approved parts only.
5. This product is fitting use standard 1/4" NPT air
fitting. If changing the fitting is required, install a 1/4"
NPT fitting of your choice, ensure that thread tape or
compound is used to seal connection.
6. Inspect before each use. Do not use if bent,
broken or cracked components are noted.
OPERATION
RAISING THE JACK
1. Block the vehicle's wheels for lifting stability.
Secure the load to prevent inadvertent shifting and
movement.
2. Position the jack near desired lift point.
3. Set the Parking Brake in the vehicle.
4. Refer to the vehicle manufacturer owner's manual
to locate approved lifting points on the vehicle.
Position the jack so that the saddle is centered and
will contact the load lifting point firmly.
5. Assemble the handle; ensure that spring clips
align with slots.
6. Close the release valve by turning it clockwise
until it is firmly closed.
7. Before raising the vehicle double check and verify
the saddle is centered and also has full contact with
the lifting point.
8. Pump handle or squeeze air trigger to lift until
saddle contacts load. (To stop air operation, simply
release the grip on the lift control valve.) Continue
to pump the jack handle to lift the vehicle to the
desired height. After lifting, support the load with
appropriately rated vehicle support stands before
working on the vehicle.
CAUTION: NEVER WIRE, CLAMP OR
OTHERWISE DISABLE THE LIFT CONTROL
VALVE TO FUCTION BY ANY MEANS
OTHER THAN BY USING THE OPERATOR'S
HAND. USE THE HANDLE PROVIDED WITH
THIS PRODUCT OR AN AUTHORIZED
REPLACEMENT HANDLE TO ENSURE
PROPER RELEASE VALVE OPERATION. DO
NOT USE EXTENSIONS ON THE AIR HOSE
OR ON THE OPERATING HANDLE.
7
Publicité
