Wamsler 101 90 SYSTEM E Mode D'emploi page 40

4.2 TYP 101 94 PLASMA
1. First remove the packaging and the
soapstone plate carefully, and then
strip the felt sheets of the base (yet the
felt sheets will be needed later on).
2. Remove the connection screws from
the pallet.
3. Turn the base by 180º, and position it
as desired.
4. Place the removed felt sheets on the
base (see the drawing), followed by
the soap stones, and adjust.
5. Position the furnace chamber on the
soapstone plate as required (right,
middle, left). Do not push the furnace
chamber, because it may scratch the
floor!
We reserve the right to make changes which relate to technical advances and / or to an
improvement in quality. We accept no liability for printing errors and changes which occur after
printing.
40