Olimpia splendid ALYAS PRO E INVERTER 9 Mode D'emploi Et D'entretien page 88

3.8 - MANUAL OPERATION
manual operation can be used temporarily if the remote control cannot be found or its batteries are discharged.
a. Open and lift the front panel to an angle in which it blocks and a "click" is heard (figure 41).
b. Press the control key once (AUTO/COOL) to start operation in "AUTO" mode (figure 42).
c. Close the panel well, taking it back to its original position (figure 46).
• By pressing the manual key, the operating passes in sequence to:
AUTO > COOL > OFF.
• Press the key twice to start the unit in forced "COOL" mode.
This mode must be used for the inspection only.
• By pressing the key a third time. operation stops and the air conditioner switches off.
• To restore remote control operation, use the remote control directly.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning, always make sure the sys-
tem has been switched off, using the remote control, and the power supply plug
has been disconnected from the system socket (or the upstream master isolating
switch is positioned at "0" OFF).
Do not touch the metal parts of the unit when removing the air filters.
They are very sharp. Cuts or injury risk.
4.1 - CLEANING
4.1.1 - Cleaning the indoor unit and remote controller
Use a dry cloth to clean the indoor unit and the remote control.
a cloth dampened in cold water can be used to clean the indoor unit if it is very dirty.
the front panel can be removed and cleaned with water. Dry using a dry cloth.
Do not use a chemically-treated or anti-static cloth to clean the unit.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
EN - 34
(figures 41 and 42)