Télécharger Imprimer la page

Zanussi ZDT26010FA Notice D'utilisation page 34

Publicité

Les langues disponibles

Les langues disponibles

Problem and alarm code
The program lasts too long.
The remaining time in the dis-
play increases and skips nearly
to the end of program time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds from
inside the appliance.
The appliance trips the circuit-
beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
Poor washing results.
Poor drying results.
34
Possible cause and solution
If the delayed start option is set, cancel the delay setting or wait
for the end of the countdown.
This is not a defect. The appliance is working correctly.
The appliance is not level. Loosen or tighten the adjustable feet
(if applicable).
The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
The appliance is not level. Loosen or tighten the adjustable feet
(if applicable).
Parts of the tableware are protruding from the baskets.
The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
Make sure that the spray arms can rotate freely.
The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible cause and solution
Refer to "Daily use", "Hints and tips" and basket loading
leaflet.
Use more intensive washing programmes.
Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
Tableware has been left for too long inside a closed appli-
ance.
There is no rinse aid or the dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher level.
Plastic items may need to be towel dried.
For the best drying performance activate the option XtraDry.
We recommend to always use rinse aid, even in combination
with multi-tablets.

Publicité

loading