Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out the mains plug or switch off
the fuse!
3. Take out the food and store in a cool
location. Place ice pack (if available)
on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
area.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the food back into the appliance.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. %
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Removing the container
Fig. ç $
Pull out the container all the way, lift at
the front and remove.
Condensation channel
Fig. (
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Take out shelves in the door
Fig. *
Lift shelves upwards and take out.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Select 560 mm cavity depth.
■
A smaller cavity depth will result in
a higher energy consumption.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
Regularly defrost the freezer
■
compartment to remove the layer
of frost.
A layer of hoarfrost will impair
refrigeration of the frozen food
and increase power consumption.
Ensure that the freezer compartment
■
door is always closed properly.
To avoid increased power
■
consumption, occasionally clean the
back of the appliance.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
en
31