Garland FUM 416 ML Manuel D'instructions page 30

English
Do not use the machine if it is damaged or
improperly regulated.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this machine for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
7.1. PREPARING THE LIQUID TO BE SPRAYED
Prepare the product mix to be sprayed in a tank
in which you can insert the suction hose with the
filter and the return hose. Always follow the product
manufacturer's instructions and safety standards.
7.2. WORK WITH THE MACHINE
1. Put the switch to "I"
2. Use the regulator to adjusting de speed
3. Start spraying the product in the desired area by
squeezing the trigger.
7.3. VOLTMETER
The voltmeter on the machine will indicate the current
battery voltage.
L
Low voltage
N
Normal voltage
F
High voltage
7.4. COMPLETION OF SPRAYING
After using the machine it is necessary to clean the
circuit using clean water. When you stop using the
machine:
1. Turn off the machine by moving the switch to the
"O" position.
2. Empty the contents of the container in a sealed
container. Do not throw leftovers from the tank onto
the ground
3. Fill the tank with clean water.
4. Start the machine again and spray clean water for
one minute to ensure that all the circuit is cleaned
with water.
5. Turn off the machine.
6. Empty the deposit.
7. Charge the battery
8. MAINTENANCE AND SERVICE
Perform periodic inspections on the machine in order
to ensure efficient operation of the machine. For a
complete maintenance we recommend that you take
the machine to your technical service.
It's always necessary to turn off the engine before
cleaning, transporting this machine.
Disconnect the "O" machine before performing any
operation on the machine. Read the instruction
manual before performing any operation on the
machine.
Never try to set up the machine if it is running.
Carry out all maintenance on the machine with it on a
flat, clear surface.
Use only suitable replacement parts for this machine
30/92