Optional Accessories - Makita DUH501 Manuel D'instruction

5. Set the angle of a file to 45°, and grind the upper
blade from 3 directions with the file.
► ( 1) File (2) 45°
CAUTION:
Before grinding the shear blades,
make sure that the tool is switched off and the
battery cartridge is removed from the tool.
6. Place the tool upside down, and then remove the
burrs from the shear blades with the file.
1
► 1 . File
7. Set the angle of the file to 45°, and grind the lower
blade from 3 directions with the file.
8. Return the tool to normal position, and then
remove the burrs from the shear blades with the file.
9. Attach the branch catcher by tightening the screw.
Grease lubrication
Interval of lubrication: Every 100 operating hours
1.
1
2
► 1 . Screw 2. Bottom cover
2.
attach the grease vessel to the hole on the cover by
turning the grease vessel.
► 1 . Cover 2. Grease vessel
3.
(0.2 oz) as a guide).
4.
5.

OPTIONAL ACCESSORIES

are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
•
•
•
•
15 ENGLISH
Remove 3 screws, and then remove the bottom cover.
1
Remove the cap from the grease vessel, and then
1
Apply the grease to the tool (Approximately 5 g
Remove the grease vessel.
Attach the bottom cover, and then tighten 3 screws.
CAUTION:
These accessories or attachments
Shear blade assembly
Shear blade cover
Chip receiver
Grease vessel
Makita genuine battery and charger
2
2