Makita DUH501 Manuel D'instruction page 10

4. Remove 2 screws, the felt pad, the washers, and
the sleeves, and then remove the shear blades.
1
2
3
4
► 1 . Felt pad 2. Screw 3. Washer 4. Sleeve 5. Shear
blades
5.
Remove the blade cover, and then attach it to the
new shear blades.
6. Adjust the crank so that 2 holes are lined up on
the alignment line.
2
► 1 . Hole 2. Alignment line
7. Align the protrusions on the shear blades vertically
at the same position.
► 1 . Protrusion
8.
5
► 1 . Felt pad
9.
hole on the rod, then align the position of the felt pad
with the holes on the tool, and then attach new sleeves
and washers.
1
► 1 . Protrusion 2. Hole 3. Felt pad 4. Washer
1
NOTICE:
inner periphery of the hole of the rod.
NOTICE:
the sleeves.
1
10 ENGLISH
Attach the felt pad to the shear blades.
Insert the protrusion on the shear blades to the
3
2
4
5
5. Sleeve
Apply a small amount of grease to the
Be careful not to lose the washers and
1
1