Publicité
Les langues disponibles
Les langues disponibles
Charging the battery
1. First switch the helicopter off.
2. Locate the charge lead on the front of the transmitter, and insert the charge connector
into the helicopter socket. Switch the transmitter on, and the LED will light up red.
3. The LED expires when the battery is fully charged. Disconnect the charge lead at this
point.
4. This method of charging takes about 30 minutes.
•
Never allow the helicopter battery to touch or come close to any hot object (open fl a-
me, heating radiator), otherwise there is a risk of explosion.
•
Store the helicopter battery in dry indoor conditions.
•
Never strike the battery with a hard object, as this could damage the cell.
•
Do not dismantle the LiPo battery.
•
The battery should never be left on charge unsupervised.
During the charge process the switch on the helicopter must be left at the OFF position.
5.
The battery can also be recharged from a PC using the USB charge lead supplied in the
set: connect the charge lead to the USB socket of a PC, and the red LED in the plug will
glow red. Insert the other end of the lead in the helicopter charge socket, and the LED will
go out. After about 30 minutes, when the battery is fully charged, the LED in the plug will
light up, and the charge lead must be disconnected. During the charge process the switch
on the helicopter must be left at the OFF position.
Remote control functions
Climb
If you slowly move the left-hand stick
(throttle stick) forward (away from you),
the main rotor blades will start to rotate
and accelerate steadily; the helicopter
takes off and climbs.
Descent
If you move the left-hand stick (throttle
stick) back (towards you), the main rotor
blades slow down; the helicopter starts
to descend.
Operating Instructions Pico Star 1 Gyro
ON
OFF
Switch
16
Publicité
