Soehnle Shape Sense Profi 300 Mode D'emploi page 6

A. Operating elements
EN
1. Minus ( )
2. Confirm ( )
3. Plus ( )
Sensor Touch:
Touch keys only slightly!
B. Preparation
1. Insert batteries.
Note:
Place the body analysis scale immediately on
a solid and even surface (as long as „0,0" is
still displayed) and wait until the scale turns
off automatically.
Only then begin with data input. Note, it
might occur that the initial scale weight is
being added erroneously to the personal
weight process.
The same may happen during regular operati-
on, if scale is held in the hand prior to the
weight process.
2. Place scale level on a hard surface (not car-
pet). This applies for all measurements.
3. Cleaning and Care: use only a lightly damp
cloth for cleaning. Do not use solvents or
abrasives. Never submerge scale in water.
4. A country-specific option, to switch from kg/
cm to lb/in or st/in, is available on the back of
the scale by pushing key.
Attention! Slipping hazard
in case of wet surface.
C. Data input
1. Push key.
2. Use / keys to select memory slot. Use
confirm. Þ P
3. Then use /
firm. Þ H
4. Enter the age and confirm.
Þ A
5. Select gender and confirm. Þ S
6. To finish, set activity level and confirm (Press
key 3 sec.). Þ AC
4
keys enter body height and con-
1 Hardly any physical activity
Slight, active, sitting and
2
standing activity
House and yard work,
3 mainly standing, sitting
only occasionally.
Athletes and people with
4
plenty of movement
Heavy manual labourer,
5
highly active athletes
Athlete Mode: The respective calorie require-
ments can be precisely determined by setting
personal activity level.
7. Place the body analysis scale immediately on
the floor, wait until screen displays „0,0".
Step barefoot on the scale.
The initial measurement is indispensable and
serves to store data for later automatic user
recognition. If user does not step on the scale,
data cannot be saved and must be entered
again.
The first body analysis is performed after a
user steps on the scale.
This scale is equipped with a Timeout mode.
It will automatically switch off after approx.
40 seconds, if no keys are pressed.
Data must be entered again after battery
change.
D. Body analysis
1. Place scale on solid and even surface and wait
until scale switches off automatically.
Step barefoot on the scale. Stand still.
2. The determined body weight is displayed. The
automatic recognition of user follows.
3. If the determined values cannot be clearly
allocated to one user, the possible memory
to
slots will be displayed.
If the determined weight can be allocated to
more than 2 users, other possible memory
slots will be displayed after 3 seconds.
Use the / keys ( = left,
firm the memory slot displayed there.
The scale measures body values (body fat,
body water, muscle mass), basic metabolic
rate (kcal) and BMI (Body Mass Index).
The 9-segment status bar shows the respecti-
ve deviation from the normal value (see over-
leaf).
The scale turns off auto matically.
intensive trai-
ning: 5 - 10 h/
week
intensive trai-
ning: min. 10 h/
week
= right) to con-