Publicité
Les langues disponibles
Les langues disponibles
Install Oven
1. Using 2 or more people, lift the oven partially into the cabinet
cutout. Use the oven opening as an area to grip.
NOTE: When pushing the microwave oven into the cabinet,
open the microwave oven door and push against the seal
area on the front frame. Do not push against the outside
edges.
2. Push against the front frame of the microwave oven to push
oven into cabinet.
3. Push the oven completely into the cabinet and center the
oven into the cabinet cutout.
4. Remove the tape from the black front trim piece.
Securely fasten the oven to the cabinet using the
■
#8-14 x
/
" screws provided.
3
4
Insert the screws through the hole in the black trim
■
piece, aligning with the hole in the oven frame. Do not
overtighten the screws.
A
B
C
A. Oven frame
B. Oven frame hole
C. Black trim piece
Install Deflector Kit Bracket
This assembly is required for use when a single or double
built-in oven is installed in a flush installation.
1. Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the deflector bracket (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also
be required to flex the deflector bracket (B) and slide it
into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the deflector bracket (B) to the lower vent piece (D)
using two #8-18 x
/
" screws on each side.
1
4
NOTE: On 27" (68.6 cm) models, only one #8-18 x
screw is used on each side.
A
A. #8–18 x
/
" screws
C. Upper vent piece (supplied with oven)
1
4
B. Deflector bracket
D. Lower vent piece (supplied with oven)
3. Align vent tab (B) with oven frame (A) as shown.
4. Using one #8-18 x
/
" screw (E) on each side of the vent
3
8
tab (B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
5. Replace the oven racks.
6. Replace the oven door. See the "Replace Oven Door"
section.
7. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
/
"
1
4
D
B
C
D
A
B
C
D. Deflector bracket
E. #8–18 x
/
" screw
3
8
B
C
7
Publicité
