Publicité
Les langues disponibles
Les langues disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools Needed
Phillips screwdriver
■
Measuring tape
■
Drill (for wall cabinet installations)
■
/
" (3 mm) drill bit (for wall cabinet installations)
1
■
8
Level
■
Flat-blade screwdriver
■
Parts Needed
(4) #8-14 x 1" screws
■
(2) #8-18 x
/
" screws - bottom vent included with
3
■
8
built-in oven
Bottom vent included with built-in oven
■
Parts Supplied
Deflector bracket
■
(2) Plastic spacers
■
#8-18 x
/
" screws - (2) for 27" (68.6 cm) models);
1
■
4
(4) for 30" 76.2 cm) models - deflector bracket
(4) #8-18 x
/
" screws - oven feet
3
■
8
(2) feet
■
(2) front feet
■
2
BUILT-IN OVEN SAFETY
Your safety and the safety of others are very important.
INSTALLATION REQUIREMENTS
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
NOTE: Refer to the following "Location Requirements" and the
"Location Requirements" section of the Installation Instructions
provided with your built-in oven.
Cabinet opening dimensions that are shown must be used.
■
Given dimensions provide minimum clearance with oven.
Recessed installation area must provide complete enclosure
■
around the recessed portion of the oven.
Oven support surface must be solid, level and flush with
■
bottom of cabinet cutout.
The floor must be able to support a total weight (microwave
■
and built-in oven) of 208 lbs (95 kg) for 27" (68.6 cm) models
or 249 lbs (113 kg) for 30" (76.2 cm) models.
IMPORTANT: To avoid damage to your cabinets, check
with your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate, or sustain other
damage. This oven has been designed in accordance with
the requirements of UL and CSA International and complies
with the maximum allowable wood cabinet temperatures of
194°F (90°C).
Publicité
