Vent Use; Led Illumination - Jenn-Air JVD0303GS Guide D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour JVD0303GS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A. Vent door
B. Vent filter
C. Filter handle
The vent removes cooking vapors, odors, and smoke from the
cooktop area. The vent consists of a vent filter, vent ducting, and
a vent fan.
For best results, the vent should be turned ON before
cooking is started.
A higher heat setting than normal may be needed when
the vent is operating.
The handle of the vent filter should be on the left-hand side
of the filter opening when facing the front of the vent. See
the previous illustration.
IMPORTANT: Only operate the vent with the vent filter properly
installed. Clean the filter regularly. Non-vented (recirculation) use
requires the installation of the Recirculation Kit Accessory.
To Use:
1
15 MIN
4

VENT USE

D. Cooktop
E. Vent controls
2
OFF
To Turn On Vent:
1. Push down on the right side of the vent door. A magnet will
keep the vent door open.
NOTE: The vent will not operate if the vent door is closed.
2. Tap the bar (
) above the "1" keypad for low speed. Tap
the bar (
) above the "2" keypad for high speed.
NOTE: The vent has a Timer On mode. Tap the bar (
the "15 MIN" keypad. The vent will only run on low speed and
will automatically turn off after 15 minutes while in the Timer
On mode.
To Turn Off Vent:
1. Tap the bar (
) above the "OFF" keypad.

LED Illumination

There is an LED light below the vent door that comes on
automatically when the vent door is opened. To turn the LED
light off when the door is open, press the LED light switch.
B
A
A. LED light
B. LED light switch
) above

Publicité

Table des Matières
loading

Table des Matières