Complete Installation; Range Hood Use; Display - Jenn-Air LI3W7D Instructions D'installation Et Guide D'utilisation Et D'entretien

7. Secure the lower duct covers together at the top using 2
plastic clips. Use one on each side.
A
A. Plastic clips (2)
B. Lower duct covers top clip area
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
A
B
C
D
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings
10
B

RANGE HOOD USE

G
E
D. Canopy
E. Grease filters
F. Grease filter handles
G. Control panel

Complete Installation

1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Control Panel
The range hood controls are located on the front side of the
canopy.
A B
Grease Filter Saturation Alarm
After 30 hours of fan function, the display will show "Clean
Grease Filter" when the fan is active. When this icon shows in the
F
display, the installed grease filters should be washed. See
"Range Hood Care" section.
To reset the grease filter saturation alarm, press and hold the
POWER INCREASE button for 5 seconds. The "Clean Grease
Filter" icon will no longer be displayed.
Charcoal Filter Saturation Alarm
After 120 hours of fan function, the display will show "Replace
Charcoal Filter" when the fan is active. When this icon shows in
the display, the charcoal filters should be replaced. See "Range
Hood Care" section.
To reset the charcoal filter saturation alarm, press and hold
the POWER DECREASE button for 5 seconds. The "Replace
Charcoal Filter" icon will no longer be displayed.
C
A. Power decrease
B. Power increase
C. Display
D. Light
E. Timer

Display

D
E