Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. MACHINE FEATURES
1.1. U
NIT APPLICATION
The machine has been designed and manufactured:
to remove oxides and burns formed during stainless steel welding and cutting operations;
to polish the welding on stainless steel;
to mark the stainless steel surfaces (optional).
Pay attention:
however you must be carefully not to use this machine on steels that can be particularly sensitive to the
liquid used (ex. Aisi 430), in which case white stains can appear. In case of doubt try a preliminary test on a
sample or please contact N
1.2. T
ECHNICAL DATAS
Model:
Supply voltage:
Phases:
Capacity:
Frequency:
Electrode voltage range:
Isolation class:
1.3. M
ACHINE COMPONENTS
1.
Torch
2.
Torch support and pad mounting tool
3.
Handle
4.
Ground cable socket
5.
Clean&Brill Kit / Marking Kit socket
6.
Power cable
7.
Power switch
8.
Reservoir Tank
9.
exhaust outlet
10.
Operating knob
1.4. P
ROTECTION DEVICES
T
HERMAL PROTECTION
The unit is protected by a special device which starts operating in case of accidental overheating of the inverter. After the
intervention of this device, the machine automatically stops working. When the temperature of the inverter is again within the
normal values, the unit automatically starts supplying electrical power.
P
ROTECTION AGAINST SHORT
The machine is equipped with a protection device against short-circuits between the insert installed on torch and the working
pieces.
1.5. M
OBILIZATION AND STORAGE OF THE MACHINE
The machine can be manually moved with a rigid handle (3), located on its upper part. Refer to the data concerning the
dimensions and weight of the machine (Paragraph 1.2). While moving the machine, do not shake or do not turn it over, to aoid
spills of any fluid remaining in the tank.
Pay attention:
in case of need to send the Machine to N
empty completely the electrolytic solution in the tank, turning upside down the machine.
N
-G
ITTY
transport.
The machine must be kept in a dry and safe place, mainly to avoid damage of its electrical components.
Before storing the machine for a longer period, empty out the electrolyte tank completely.
-G
ITTY
RITTY
TIG.CLINOX EVO
See front panel
Single-phase + neutral + ground
1100 W
50/60 Hz
10/30 V AC/DC
IP20
(P
A)
ICTURE
-
CIRCUITS
is not liable for damage or injury due to fluid spills from the tank during movement or
RITTY
- EN -
Customer Assistance Department for further information.
Extraction capacity:
Head:
Motor RPM:
Noise:
Tank capacity:
Machine weight (empty):
Machine dimensions:
11.
Current knob
12.
Electrolyte warning led
13.
Pump knob
14.
Technical data
15.
Hexagonal screws
16.
Tungsten standard insert
17.
Protective cup
18
Torch buttons: ON/OFF
19.
Ground cable
20.
Cup
'
Assistance Center for a reparation, it's necessary to
-G
ITTY
RITTY
S
- 28 -
3
150 m
/h
1600 mm
16000 rpm
<81,5 dB (A)
1,8 L
14,5 kg
195x340x550 mm
Publicité
Table des Matières
