Electrolux EN6084JOX Notice D'utilisation page 8

8 www.electrolux.com
5. INSTALLING YOUR NEW APPLIANCE
This section explains the installation of
the new appliance before using it for the
first time. We recommend reading the
following
WARNING!
For proper installation, this refrig-
erator must be placed on a level
surface of hard material that is
the same height as the rest of the
flooring. This surface should be
strong enough to support a fully
loaded refrigerator, or approxi-
mately 266 lbs. (120 kg).When
moving, be sure to pull out and
push back the unit in straight. tips.
Class
Extend
Temperate
Temperate
Subtropical
Tropical
5.1 Leveling of appliance
For proper leveling and avoid vibration,
this appliance is provided with adjustable
feet in front. Please adjust the level by
following below instructions:
1. Roll the refrigerator into place.
2. Turn the adjustable feet (with your
fingers or a suitable spanner) until
they touch the floor.
Ambient
Symbol Temperature
rage(°C)
SN +10 to +32
N +16 to +32
ST +16 to +38
T +16 to +43
3. Tilt back the top backwards for
about 10-15 mm by turning the feet
1~2 turn further. This will allow the
doors to self-close and seal properly.
4. Whenever you want to move the
appliance, remember to turn the feet
back up so that the appliance can roll
freely. Reinstall the appliance when
relocating.
10-15mm
Front roller
Adjustable foot
WARNING!
The rollers, which are not castors,
should be only used for forward or
backward movement. Moving the
refrigerator sideways may damage
your floor and the rollers.
5.2 Adjusting the door handle
Before you use the appliance, please
check the refrigerator handles. If the
handles are loose, please adjust them by
using an Allen wrench in the clockwise
direction until handles are securely in
place. Each one of the handles is fitted
with 2 screws.
Allen wrench (Provided)
Rear roller
Hexagon socket set
screws