User Manual; Cat5E/Cat6 Cable Requirements - Marmitek MegaView 60 Guide Utilisateur

2. CONTENT OF THE PACKING
MegaView60
1x transmitter (HDMI Transmitter)
1x receiver (HDMI Receiver)
1x Power adapter
1x User manual

3. CAT5E/CAT6 CABLE REQUIREMENTS

• UTP-, FTP- or STP-cable
• 24AWG or lower
• Solid twisted pair
• 100 ohm at 1MHz
• RJ-45 jack according to EIA/TIA T568B standard
Instead of CAT5e cable, CAT6 cable may also be applied (this offers better quality). Use a
'solid twisted pair CAT-5e or CAT-6 cable' in order to optimise transfer quality.
4. INSTALLATION
HD Settop box
HDMI
Blu-ray player
1
MediaCenter PC
In order to ensure that the system is working properly you are advised to check the set-up
with short CAT-5e/6 cable lengths first.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (HD-DVD player, blu-ray disc player, HD set-top box, game
console, etc.) to the MegaView60/61 transmitter [1], using an HDMI cable (not provided).
3. Connect the MegaView60/61 receiver to the appliance shown [2] (e.g. HDTV or projector),
using an HDMI cable (not provided).
4. Use two CAT5e/6 Ethernet cables to connect the MegaView60/61 transmitter with the
MegaView60/61 receiver [3&4].
*The RJ45 plug on these cables must be connected according to EIA/TIA T568B standard,
see attachment page 39.
Make sure that the CAT5e/6 cable and the transmitter and receiver connections (CAT5e-1 en
CAT5e-2) correspond to one another.

MegaView61
1x transmitter (HDMI Transmitter)
1x receiver (HDMI Receiver)
1x Infrared receiver
1x Infrared extender cable with 2 IR LEDs
1x Power adapter
1x User manual
IR Extender
6
CAT5e-2
3 & 4
HDMI Transmitter
CAT5e-1
HIGH SPEED CAT5e/6 EXTENDER
IR Receiver
7 5
HDMI Receiver
HIGH SPEED CAT5e/6 EXTENDER
HDMI
HDTV
2
© MARMITEK