Frigidaire E30MH65QPS Instructions D'installation page 18

ADAPTING MICROWAVE
B5.
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
Roll the blower unit 90°
3
Before Rotation
Back of
Microwave
4 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave
Gently remove the wires from the grooves.
5
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through Right Side
Roll the blower unit 90° so that fan blade
6
openings are facing out the back of the
microwave.
Before Rolling
Back of
Microwave
Installation Instructions
After Rotation
Back of
Microwave
After Rotation
Back of
Microwave
After Rerouting
Wires Routed Through Left Side
After Rolling
Back of
Microwave
7
Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
Secure the blower unit to the microwave with
8
the original screw.
9
Replace the blower plate in the same position
as before with the screw. Make sure the screw
is tight.
10
Attach the exhaust adaptor to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
EN-18
Blower Plate
Back of
Microwave
Blower Motor
Screw
Adaptor
Locking Tabs
End A
Back of
Microwave
Guide