Identification And Servicing; After-Sales Service - Grillo PX31 Manuel D'utilisation

25) Always use original Grillo spare parts.
26) Before starting any work with the machine, check that all the accident prevention systems with
which it is equipped are in perfect working order. They must never be disabled or tampered with.
27) Before starting work, check that the nuts and bolts securing the tiller and hoes are perfectly
tight.
28) All protective fittings (hoods, mudguards, etc.) must be kept in place during operation.
29) Never clean the tiller with the engine running.
30) Never use the machine barefoot.
31) Never change the engine settings, especially the maximum r.p.m.
32) Allow the engine to cool before placing the machine indoors.
33) CAUTION: to reduce the risk of fire, keep the engine, the exhaust pipe and the exhaust
manifolds free from grass, leaves, dust, etc...
34) If you have to empty the fuel tank, do this outdoors.
35) Rotavator must be driven by only one operator.

AFTER-SALES SERVICE

This handbook provides instructions for use of the motor hoe and for correct basic servicing which
the user can carry out himself. For all procedures not described in this handbook, contact your
local dealer.
SPARE PARTS
Always use original spare parts, as they are the only ones to offer complete safety and
interchangeability. Always state the serial number of the machine and the code number or the part
to be replaced when ordering. For engine parts, refer to the specific handbook.
GUARANTEE
The guarantee is given in compliance with the current law. The dealer will have to give the client a
copy of the registration card of the machine, which they will print up from the Grillo website.
For the engine the guarantee of the relative manufacturers apply.
ORDERING SPARE PARTS
Always state the machine serial number and the code number of the part to be replaced.
Contact your local dealer. For further information, our address is:
GRILLO S.p.A.
Via Cervese 1701 - 47521 CESENA (FC) - ITALY
Tel. 0039 / 0547 / 633111 - Fax 0039 / 0547 / 632011
Web site: www.grillospa.it - E-mail:
RECOMMENDED SPARE PARTS TO HAVE AT DISPOSAL
1 throttle lever
1 tiller engagement cable
PX31-32/ Translation of the original instructions
IDENTIFICATION AND AFTER-SALES SERVICE
PX31
PX32
grillo@grillospa.it
The rotavator is fitted with a nameplate on
the frame with the serial number of the
machine. Always state the serial number
when ordering spare parts or asking for
technical support.
5