DeWalt D25872 Guide D'utilisation page 7

Bail/Loop Style Auxiliary Handle (Fig. B)

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the bail/loop style
auxiliary handle properly installed. Failure to do so
may result in the bail/loop style auxiliary handle
slipping during tool operation and subsequent
loss of control. Hold tool with both hands to
maximize control.
The bail/loop style auxiliary handle
the gear case and may be rotated 360˚ to permit right- or
left-hand use.
Mounting the Bail/Loop Style Auxiliary
Handle (Fig. B)
1. Widen the ring opening
auxiliary handle 2 by rotating the screw for handle
mounting counter clockwise.
10
2. Slide the assembly onto the nose of the tool, through
the steel ring and onto the collar
11
holder and sleeve.
3. Rotate the bail/loop style auxiliary handle to the
desired position.
4. Lock the bail/loop style auxiliary handle in place by
securely tightening the screw for handle mounting
rotating it clockwise so that the assembly will not rotate.
Fig. B
11
10
Chisels and Chisel Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing chisels. Accessible metal parts on the tool
and chisels may get extremely hot during operation.
Small chisels of broken material may damage
bare hands.

WARNING: Do not attempt to tighten or loosen drill
chisels (or any other accessory) by gripping the front
part of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur.
The chipping hammer can be fitted with various chisels
depending on the desired application. Use sharp
chisels only.
clamps to the front of
2
11 of the bail/loop style
, past the chisel
3
10
3
2
Inserting and Removing SDS MAX
Chisels (Fig. C)
nOTE: Accessories and attachments used must be
lubricated around the SDS MAX fitment before installation.
1. Insert chisel in the chisel holder 6 and apply downward
pressure while rotating to secure the chisel into place.
The chisel shank must be clean.
2. Ensure the chisel is properly engaged.
nOTE: The chisel needs to move several centimeters in
and out of the chisel holder
Fig. C
6
3. To remove the chisel pull back the locking sleeve
pull the chisel out.
Chisel Position Adjustment
Turn the mode selector to chisel adjustment icon (Refer to
Mode Selection) to adjust the chisel to the desired position.
There are multiple positions to set the angle of the chisel.
nOTE: After finding the desired position, slightly
maneuver the chisel back and forth to ensure the chisel is
properly engaged.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the mounted
side handle 2 with the other hand on the main handle
Fig. D
2
English
when properly engaged.
6
7
7 and
5 .
5
5