Inverting The Door (Exception Made For Glass Door Versions) - Sagi ME70LTR Manuel D'utilisation Et D'installation

All equipment which must be disposed of in accordance with the WEEE Directive 2002/96/EC is marked with
a special symbol
.
The improper disposal of Waste Electrical and Elec¬tronic Equipment is liable to punishment under
the relevant laws in the countries where the offence is committed.
Waste electrical and Electronic Equipment may con¬tain hazardous substances with potential
harmful ef¬fects on the environment and human health. You are urged to dispose of them properly.

INVERTING THE DOOR (exception made for glass door versions)

Refrigerator cabinets are normally supplied with opening to the right.
To invert the door (hinge on the left side) follow this procedure:
• Rotate the instrument panel on the side heads by removing the "F" screw.
Warning: in models "...T" and "Ice cream" also remove the panel by unscrewing the screws "X" found on
the side heads over to the vine "stops" dashboard "F".
• Remove the two fixing screws of the bracket "A" and the holding screw of the hinge "B".
• Extract the door, remove the hinge "B" and the component "E" and invert their position.
• Remove the component "C" and install it on the opposite side of the door.
• Remove the lower bracket "d" and install it in its housing on the opposite side.
• Place the door by introducing the hole of the lower component "E" into the pin of the bracket "D".
• Fix the bracket "A" to the structure on the opposite side by tightening the fixing screws.
• Before tightening the bracket screws, check the hinge height (12 mm approx.) and the door perpendicular
position with respect to the structure.
• Replace the panel board
NOTE: Keep the door closed when removing and installing the brackets.
34