Etherma LAVA 2.0 250 W Instructions D'installation Et D'utilisation page 6

N O T E S
IMPORTANT NOTES:
› LAVA infrared heating devices comply with the relevant
®
safety requirements.
› Installation and initial start-up, as well as repairs and servicing,
may be carried out by a licensed specialist or qualified individ-
ual only. All safety regulations must be observed. This person
must verify first whether the electrical in-house system
complies with the relevant standards. The responsibility of
the manufacturer is limited to supply of the device.
› Comply with country-specific safety regulations.
› Comply with local safety precautions.
› The devices are suitable for the installation on walls and on
ceilings.
S C O P E O F D E L I V E R Y | P A C K A G I N G
The LAVA ® infrared heating must be mounted exclusive-
ly using the fixing components included in the scope of
delivery.
STANDARD SCOPE OF DELIVERY FOR WALL MOUNTING:
› LAVA ® 2.0 INFRARED HEATING
- 2 x mounting brackets
- 4 x hexagon bolts M8 x 16
C L E A R A N C E S
INSTALLATION AND MINIMUM DISTANCES:
LAVA infrared heating devices have to be mounted so that
®
flammable objects cannot catch fire. Be absolutely sure to
comply with minimum clearances, in particular to highly com-
bustible objects such as curtains, upholstered furniture, etc.
Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION: Strain of any kind on the surface,
whether from persons or objects leaning against it
or from other forces, must be avoided!
10
› Protective areas must be observed in accordance with DIN
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
› In bathrooms, the device must be mounted so that switches
or other regulators cannot be touched by persons in a bath-
tub or shower.
› Due to the low surface temperature at the rear side (up to
40 °C) the infrared heating may also be mounted on wooden
panelling.
› The device is not intended for the use in wardrobes and
beneath church benches.
Screws and dowels (not included in the scope of delivery) must
correspond to the construction material of the wall (masonry,
concrete, plasterboard, etc.). The surface of the wall must be
even.
ATTENTION: The wall must be even. Otherwise
damages on the surface of the LAVA ®
heating device may occur.
35 mm
35 mm
35 mm
35 mm
Dimensional drawing: minimum mounting clear-
ances
W A L L M O U N T I N G
INSTALLING THE DESIGN INFRARED HEATING:
Please inspect the power supply cord to the heater and the
surface before installation. These must not show any signs of
damage.
Fasten hexagon bolts loosely on the rear side of the device.
1. Select a position for the mounting brackets according to the
illustrations on page 12, depending on the product type.
2. Drill the holes according to the hole clearances specified on
page 12 or the drill template supplied.
3. Screw on the mounting brackets using suitable dowels and
screws.
4. Insert the LAVA infrared heating on the mounting brackets
®
and tighten the screws.
1
infrared
!!!
3
ATTENTION:
in the scope of delivery and must correspond to the
construction material of the wall.
ATTENTION:
and use the prescribed mounting holes.
2
+
+ +
8 x +
+
+
+
+
4
Screws and dowels are not included
Observe the minimum clearances
8 x
11