Blackstone 1554 Manuel De L'utilisateur page 7

6. Turn the coupling nut clockwise and tighten to a full
stop. The regulator will seal on the back-check feature in
the LP tank valve, resulting in some resistance.
additional one-half to three-quarters turn is
required to complete the connection. Tighten by
hand only – do not use tools.
NOTE:
If you cannot complete the connection, disconnect
regulator and repeat steps 5 and 6. If you are still unable
to complete the connection, do not use this regulator!
Call (435) 252-3030 for identical replacement parts.
DANGER
!
•
Do not insert any tool or foreign objects into the
valve outlet or safety relief valve. You may
damage the valve and cause a leak. Leaking
propane may result in explosion, fire, severe
personal injury, or death.
•
If a leak is detected at any time, STOP and call
the fire department.
•
If you cannot stop a gas leak, immediately close
LP tank valve and call LP gas supplier or your
fire department!
WARNING
!
•
Never attempt to attach this grill to the
self-contained LP gas system of a camper trailer
or motor home.
•
Do not use grill until leak-tested.
Leak Testing Valves, Hose and Regulator
1. Turn all griddle control knobs to OFF.
2. Be sure regulator is tightly connected to
LP tank.
3. Completely open LP tank valve by turning OPD
hand wheel counterclockwise. If you hear a
rushing sound, turn gas off immediately. There
is a major leak at the connection. Correct
before proceeding by calling for replacement
parts at (435) 252-3030.
4. Brush soapy solution onto areas where bubbles
are shown in picture below:
An
!
If "growing"
5.
Close LP tank valve immediately and retighten
connections.
do not try to repair. Call for
parts at (435) 252-3030.
6. Always close LP tank valve after performing
leak test by turning hand wheel clockwise.
!
7
bubbles appear, there is a leak.
If leaks cannot be stopped
replacement