Blackstone 1554 Manuel De L'utilisateur page 10

WARNING
!
Turn controls and gas source or tank OFF
when not in use.
CAUTION
!
If ignition does NOT occur in 5 seconds,
turn the burner controls OFF, wait 5
minutes and repeat the lighting
procedure. If the burner does not ignite
with the valve open, gas will continue to
flow out of the burner and could
accidently ignite with risk of injury.
Burner Flame Check
•
Light burners, rotate knobs from to low. You
should see a smaller flame in low position than
seen on. Perform burner flame check on
side burner, also. Always check flame prior
to each use. If only low flame is seen refer to
"Sudden drop or low flame" in
the Troubleshooting.
Turning Grill Off
•
Turn all knobs to the OFF position. Turn LP
cylinder OFF by turning hand-wheel clockwise
to a full stop.
Ignitor Check
•
Turn gas off at LP cylinder. Press and hold
electronic ignitor button. "Click" should be
heard and spark seen each time between each
collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
•
Important: Make sure gas is off at LP cylinder
before checking valves. Knobs lock in OFF
position. To check valves, first push in knobs
and release, knobs should spring back. If
knobs do not spring back, replace valve
assembly before using griddle. Turn knobs to
low position then turn back to OFF position.
Valves should turn smoothly.
Hose Check
•
Before each use, check to see if hoses are cut
or worn. Replace damaged hoses before using
griddle. Use only identical replacement part
!
valve/hose/regulator as specified in the Parts
List of this Use and Care Guide.
General Griddle Cleaning
•
Do not mistake brown or black accumulation
of grease and smoke for paint. Interiors of gas
grills are not painted at the factory (and should
never be painted). Apply a strong solution of
!
detergent and water or use a griddle cleaner
with scrub brush on insides of griddle lid and
bottom. Rinse and allow to completely air dry.
Do not apply a caustic griddle/oven cleaner to
painted surfaces.
•
Plastic parts: Wash with warm soapy water and
wipe dry. Do not use Citrisol, abrasive
cleaners, degreasers or a concentrated griddle
cleaner on plastic parts. Damage to and failure
of parts can result.
•
Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water.
Wipe dry with a soft nonabrasive cloth.
•
Stainless steel surfaces: To maintain your
griddle's high quality appearance, wash with
mild detergent and warm soapy water and wipe
dry with a soft cloth after each use.
•
Baked-on grease deposits may require the use
of an abrasive plastic cleaning pad. Use only in
direction of brushed finish to avoid damage. Do
not use abrasive pad on areas with graphics.
•
Cooking surfaces: If a bristle brush is used
to clean any of the griddle cooking surfaces,
ensure no loose bristles remain on cooking
surfaces prior to grilling.
10