tomado TVC0501W Mode D'emploi page 16

SWITCHING THE VACUUM CLEANER ON AND OFF
on the handle to the first position to switch on the vacuum cleaner. The vacuum cleaner will function
Slide the on/off button
in normal mode. Slide the on/off button to the next position to activate the turbo mode.
Fully slide back the on/off button to switch off the vacuum cleaner.
The turbo brush starts to rotate automatically when the vacuum cleaner is switched on. The turbo brush has been provided
with LED lighting.
USING THE VACUUM CLEANER AS A HANDHELD VACUUM CLEANER
The vacuum cleaner can also be used as a handheld vacuum cleaner, in order to clean furniture or car seats for instance.
Remove the stick - fig. 4 and place one of the accessories on the nozzle of the vacuum cleaner.
The handheld vacuum cleaner can be used with the turbo brush, crack nozzle or combination brush nozzle
on the handle to the first position to switch on the vacuum cleaner. The vacuum cleaner will function
Slide the on/off button
in normal mode. Slide the on/off button to the next position to activate the turbo mode.
Fully slide back the on/off button to switch off the vacuum cleaner.
The combination brush nozzle can be used in two ways: with or without a brush.
After each use, place the vacuum cleaner back on the suspension bracket. Once the adapter is connected and the connector
is inserted into the connection of the vacuum cleaner, the battery will charge. Once the battery is fully charged, remove the
adapter from the socket and the appliance.
Regularly check the filters to prevent problems. Empty the dust reservoir when it is full and clean or replace the filters when
they are dirty.
EMPTYING THE DUST RESERVOIR
It is recommended emptying the dust reservoir after each use. The dust reservoir is full when the amount of dirt has reached
the max line. Remove the accessories prior to emptying the dust reservoir - fig. 4.
• Hold the vacuum cleaner above a waste bin and remove the cover from the dust reservoir - fig. 5.
• The cover falls open - fig. 6. Gently shake the dust reservoir empty into the waste bin and close the cover in such a way
that it snaps in place.
CLEANING THE CYCLONE SYSTEM AND FILTERS
First remove the accessories and empty the dust reservoir before cleaning the vacuum cleaner - fig. 4. Clean the filters and
cyclone system after each 4th time that the dust reservoir is emptied.
• Press the knob to disconnect the dust reservoir and remove the dust reservoir from the vacuum cleaner - fig. 7.
• The entire dust reservoir comes away from the vacuum cleaner - fig. 8 and 9. Make sure you hold the dust reservoir upright
to prevent the filter and cyclone system from falling out.
• Remove the filter and cyclone system from the dust reservoir.
• Clean the filter and cyclone system with lukewarm running water and allow the components to dry in the air. Do not use
cleaning agents or brushes. It is possible that the filter does not return to its original colour after cleaning. This discolouration
does not have an effect on its function.
• The cyclone system consists of two parts. In order to clean the cyclone system thoroughly, you can dismantle the cyclone
system. Unscrew the bottom side with the inner filter. Clean the parts with lukewarm running water. Do not use cleaning
agents or brushes. Allow the parts to dry in the air.
• Re-assemble all parts when everything is fully dry and place them back in the dust reservoir in reverse order.
Caution: the cyclone system fits in the dust reservoir in only one way.
• Properly connect the dust reservoir to the vacuum cleaner and make sure it snaps in place.
USE
MAINTENANCE
EN - 16