The Controls Of Your Wine Cooler; Setting The Temperature; Function Instruction - Danby Silhouette Professional DWC031D1BSSPR Manuel Du Propriétaire

The Controls of your
Wine Cooler
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ' ' Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ' ' Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controlled by the reed
swith, and keep lighting.)
Setting the
Temperature
NOTE
When you plug in your
wine cooler for the first
time, the temperatures
will automatically be set
to 54°F (12°C) and will be
displayed in the
Fahrenheit scale (°F).
Function
instruction
NOTE
If too many bottles are put in at
once or the door has not been
closed tightly, the unit will display the
"HI" signal in the display panel. This
is normal. Please wait 5 minutes
after you close the door and
"HI" will disappear.
It is normal that the cabinet
shows "HI" or "LO" from time to time,
If it occurs frequently or lasts for a
long time, you can restart the unit by
unplugging it. If the problem
occurs once again after restart,
please contact customer service.
Operating Instructions
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
' Button
5. '
Used to raise (warmer) the temperature
in 1° degree increments.
' ' Button
Used to decrease (cooler) the
temperature in 1° degree decrements.
• The temperature range can
be set as low as 39°F (4°C)
or as high as 64°F (18°C) to
suit your specific storage
requirements. Each depres-
sion of the or
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
mentioned range.
• Temperature Memory Function
In the event of a power interruption the Wine Cooler can remember the
previous temperature settings, and when the power is restored the
cabinet temperature will go back to the same setting temperature as
before.
Door Ajar Alarm Function
•
If the door is not closed completely the alarm will sound after 5 minutes.
Please close the door completely to avoid the loss of cold energy.
• Temperature Alarm Function
If inner temperature is higher than 73°F(23°C), "HI" is shown
in the display panel, and the alarm will sound after one hour.
If inner temperature is lower than 32°F(0°C), "LO" is shown in the
display panel and the alarm will
guide on page 11 for more information.
6
°
°
• To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the
control buttons simultaneo-
but- usly for approximately
five(5) seconds.
sound . Refer to the trouble shooting
and