Husqvarna LC 142iS Manuel D'utilisation page 18

LED on the battery
The error LED is on.
Battery charger
LED on the battery
charger
The error LED flash-
es.
The error LED is on.
Lawn mower
The warning indicator (error LED) is found below the
battery lid.
Problem Error LED (number
of flashes)
Error LED flash- 5
es. The product
does not operate
correctly.
6
10
1
Only for LC 142iS
18
Cause
The cell difference too much (1V).
Cause
The temperature in the work en-
vironment is too high or too low.
Cause
The blade is blocked.
The motor speed drops too
much, and the motor stops.
1
The wheels or transmission is
blocked.
The motor control is too hot.
Solution
Speak to an approved service agent.
Solution
Use the battery charger in temperatures between 5 °C -
40 °C.
Speak to an approved service agent.
Solution
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
possible obstacles and make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an approved
service agent.
Increase the cutting height. Refer to
set the cutting height on page 14 .
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
the possible obstacles and make sure
that the wheels can rotate freely. If
the problem continues, speak to an ap-
proved service agent.
Stop the motor and wait until it has be-
come cool.
To
1692 - 005 - 03.11.2022