GRE SAFRAN Notice De Montage page 110

POSITIONING OF THE SEALING PIECES
EN
Ref.790086
Ref.790087
Ref.790088
Ref.790089
A
REFILLING FITTING WITH KEY
Start filling the pool with water, up to 4 cm. from the lower edge of the valve hole.
Mark the hole with a felt tip pen (A) and cut a cross in the centre of the opening (B) with a cutter (BLADE),
without going over the hole of the die cut.
From inside the pool, insert through the cut (C), the return valve (No. 1) with one of the friction rings (No. 2)
and one of the seals (No. 3). The pieces of liner that stick out through the outer part of the pool, should be cut
cleanly and accurately.
The other gasket (No 3.1) is placed from the outside, folding it, so that it is in contact with the liner and the
panel.
Place the other friction ring (No 3.1) and tighten firmly with the nut. Thread the connector tube previously
prepared with Teflon into the body of the nozzle, from outside of the pool.
Insert the return hose which goes from the outlet of the treatment unit to the return valve, and secure it with
the clamp.
Important: Before placing the hose, insert the trim. (No 5)
Make sure that the filter apparatus valve is in the CLOSED position.
Install the filter before continuing with
cutting the liner.
SKIMMER
ASSEMBLING THE SKIMMER
Before installing the skimmer to the pool, the gate unit must be installed in the skimmer opening.
Then place the seal (No. 5) as indicated in A
ANCHORING THE SKIMMER
Continue filling the pool with water until it reaches a level of 4 cm. under the die-cut of the skimmer of the pool wooden.
Cut the liner using the cutter (blade) following the line of the die cut.
B C
5
D
2.1
3.1
110
E
Look for us in our YouTube
channel to help you with
the assembly.
1- Body of the nozzle
2- 2.1 Round flat seal
3- 3.1 Seal
4- Nozzle body nut
5- Trim