Publicité
Les langues disponibles
Les langues disponibles
Install the Hood
1 ] Run house power cable between service panel and hood location. Run the house power
2 ] Hang hood from (4) mounting screws previously installed. Slide hood back towards wall until
3 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.
Connect the Wiring
12
1 ] Connect House Power Cable to range hood wiring: BLACK to BLACK, WHITE to WHITE and
cable into the hood through the strain relief previously installed in step 6 on page 9.
mounting screw heads are engaged in narrow end of keyhole slots in top of hood. Tighten
screws securely. Attach power cable to the hood using the strain relief.
DUCTED INSTALLATION ONLY
Make sure the damper assembly (or round duct plate) enters the ductwork and that the damper
opens and closes freely.
Risk of electric shock. Electrical wiring must be done by qualified
personnel in accordance with all applicable codes and standards.
Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power from being switched
on accidentally.
GREEN or bare wire under GREEN ground screw.
!
WARNING
HOUSE
POWER CABLE
MOTOR
GROUND
WIRE
GROUND
SCREW
Publicité
