Dexter 650ID2.5 Mode D'emploi page 202

FR
6. OPERATION
ES
Drilling metal
For maximum performance, use HSS drill bits for metal drilling.
PT
Set the tool to the drill mode.
IT
Use a suitable lubricant for the material you are working on.
Begin drilling at a very low speed to prevent the bit fr
Always clamp sheet metal. Support thin metal with a block of wood to avoid distorting it.
EL
Drilling masonry
PL
For maximum performance, use high quality carbide-tipped masonry drill bits when drilling holes in brick, tile, concrete etc.
Use the drilling mode initially then revert to the impact mode once the holes are established.
UA
Apply light pressure and medium speed for best results in brick.
Apply additional pressure and high speed for hard materials such as concrete.
RO
When drilling holes in tile, practice on a scrap piece to determine the best speed and pressure.
EN
7. MAINTENANCE
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always
replace the two brushes at the same time)
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
Lubrication
All the bearings in this tool are lubricated with a
therefore no further lubrication is required.
centre of the hole using a centre punch.
NOTE: Reverse rotation during impact drilling may damage the drill and a drill bit.
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent in order to avoid a hazard.
rting point.
nt amount of high grade lubricant for the life of the unit under normal operating conditions,
202