Publicité
Les langues disponibles
Les langues disponibles
6
Install bolt and strike.
6a Adjust bolt length, if necessary.
• If the backset (see step 4 on page 5) of your door was 2C\," (60 mm), you do not
need to do anything. Proceed to step step 6b.
• If the backset (see step 4 on page 5) of your door was 2C\v" (70 mm), you need to
adjust your bolt. Twist the faceplate until the button pops into the 2C\v" space.
Twist the
faceplate.
6b Change the faceplate, if necessary.
L In step 6c, your installation will depend on which kind of door edge you had in this step.
If your door looks like this, you don't
need to do anything. Go to step 6c.
alternate Mortise
Use the square-corner faceplate if
desired. A square-corner faceplate can
be purchased from Customer Support.
1. Use a flathead screwdriver to pry the
faceplate off.
2. Press the square-corner faceplate
into place. The faceplate may
not stay in place until screws are
installed in next step.
3. Go to step 6c, Figure A.
6
Mortise
OR
If your door looks like this, complete the
steps below.
OR
1. Use a flathead screwdriver to pry the
faceplate off.
2. Remove the backplate.
3. Slide the round faceplate into place.
4. Go to step 6c, Figure B.
Make sure the button
pops into place.
No Mortise
Publicité
