Unpacking, Installation And Starting; Place Of Installation, Place Of Use; Unpacking - KERN MPS 200K100NM Mode D'emploi

6 Unpacking, installation and starting

6.1 Place of installation, place of use

The scale is designed in such a way that reliable weighing results can be achieved
under normal application conditions.
By selecting the correct location for your scale, you will be able to work quickly and
precisely.
Therefore, please observe the following when choosing a place of installation:
Place the scale on a firm, level surface;
-
Avoid extreme heat as well as temperature fluctuation caused by installing the
-
scale next to a radiator or in the direct sunlight;
Protect the scale against direct draughts due to open windows and doors;
-
Avoid shaking during weighing;
-
Protect the scale against high humidity, vapours and dust;
-
Do not expose the device to extreme dampness for longer periods of time. In-
-
admissible bedewing (condensation of air moisture on the device) can occur if
a cold device is taken into a significantly warmer environment. In this case,
please keep the device for approx. 2 hours at room temperature after it has
been disconnected from mains supply;
Avoid static charge build-up on the scale and people to be weighed;
-
Avoid contact with water.
-
Major display deviations (incorrect weighing results) are possible if electromagnetic
fields occur (e.g. coming from mobile phones or radio equipment) as well as due to
static charging and instable power supply. It is necessary then to change the scale
location or remove disturbance source.

6.2 Unpacking

Carefully remove individual scale parts or the whole scale from its packaging and po-
sition the scale in its intended working location. When the mains adapter is used, be
careful not to cause the danger of falling over the power cable.
MPS / MTS / MWS / MXS-BAPS-e-1912 9