Table Des Matières; General Information - Hilti WSC 7.25-A36 Mode D'emploi

ORIGINAL OPERATING INSTRUCTIONS
WSC 7.25-A36 cordless circular saw
It is essential that the operating instructions
are read before the power tool is operated for
the first time.
Always keep these operating instructions to-
gether with the power tool.
Ensure that the operating instructions are
with the power tool when it is given to other
persons.
Contents
1 General information
2 Description
3 Accessories
4 Technical data
5 Safety instructions
6 Before use
7 Operation
8 Care and maintenance
9 Troubleshooting
10 Disposal
11 Manufacturer's warranty - tools
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.

1 General information

1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
In these operating instructions, the designation "the
power tool" always refers to the WSC 7.25-A36 circu-
lar saw.
Operating controls and indicators 1
Battery
@
Release buttons with additional function (charge
;
status display activation)
Charge status and fault display (Li-ion battery)
=
On / off switch
%
Switch-on interlock
&
Auxiliary grip
Page
(
Drive spindle lockbutton
1
)
Hexagon socket wrench
2
+
Cutting angle scale
4
§
Clamping lever for cutting angle adjustment
4
/
Clamping screws for the parallel guide
5
:
Clamping lever for cutting depth adjustment
8
·
45°cutting line indicator
9
$
0°cutting line indicator
11
£
Parallel guide (rip fence)
12
|
Pivoting guard
12
¡
13
Base plate
Q
Guard
W
Drive spindle
E
Mounting flange
R
Clamping flange
T
Clamping screw
Z
Cutting depth scale
U
Pivoting guard operating lever
I
Chip deflector guard
O
Chip deflector guard release
P
Angle extender for 50° cuts
Ü
NOTE
Draws attention to an instruction or other useful informa-
tion.
1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning: Warning:
electricity caustic
substances
en
Warning: hot
surface
1