Graef WK 70 Serie Mode D'emploi page 18

The unit must be set up on a firm, flat, level and non-slip base that has sufficient load bearing ca-
x
pacity.
Make sure the unit cannot fall over.
x
Select the location so that children cannot reach the hot surfaces of the unit and cannot touch the
x
cable.
Before the first use
Read these operating instructions thoroughly and keep them handy for referral later on.
This unit brings water to boil in a few minutes.
To clean the unit, first fill the unit with clear, cold water and then boil it. Subsequently pour away the
water.
Boiling water
Take hold of the base station and unwind the cable as far as it goes.
x
Open the lid  and fill the unit with water 
x
Important
Make sure you do not exceed the internal maximum filling level mark.
Fill the unit so that the water level is definitely between the minimum and maximum indicator line.
Close the lid  and put the unit back onto the base station .
x
Plug the plug into the electric socket.
x
Please press the button for the desired temperature 
x
EN
17