Publicité
Les langues disponibles
Les langues disponibles
Preparing to connect the water
(only for appliances which require a water connection)
Note:
Turn off the main water tap to prevent damage caused
by leaking water.
1.
Attach the water line to the shut-off valve according
to the instructions supplied by the manufacturer of
the ice maker installation kit.
2.
Install the water line.
Always observe the indicated dimensions to prevent
damage to the water line when pushing in the
appliance.
Connecting the water to the appliance
Note:
When bending the water line, do not kink it, otherwise
there is a risk of leaks and water damage.
1.
Remove the cap from the appliance connection (1.).
2.
Bend the water line according to the location of the
connection on the appliance (2.).
3.
Push the union nut and seal onto the water line.
4.
Push the end of the water line into the appliance
connection and screw on the union nut (3.).
Tighten hand-tight.
5.
Using the open-ended wrench, tighten the union nut.
Do not overturn!
6.
Push back the water line into the guard tube as far
as possible (4.).
7.
Open the shut-off valve and main water tap.
8.
Check the connection on the shut-off valve and on
the appliance for leaks.
9.
Close the shut-off valve.
Adjusting the door opening angle
Depending on the installation situation, it may be
necessary to adjust the door opening angle. A door
opening angle of 115° has been set at the factory.
To adjust the door opening angle to 90°:
1.
Open door to 90°.
2.
Insert the banking pin through the boreholes which
are now vertically aligned and drive in with
a hammer.
29
Publicité
