Publicité
Les langues disponibles
Les langues disponibles
4.
Pushing the appliance into the
installation enclosure
,
CAUTION:
Caution when pushing the appliance into the
installation enclosure. Do not damage the water
line or power cord.
Note:
When the floor or the appliance is not leveled in
comparison to the installation enclosure adjust height
adjustable wheels before you move the appliance into
the installation enclosure.
1.
Remove the base panel.
2.
Raise the height-adjustable wheels at the back
3
by approx.
/
" (10 mm).
8
3.
Put the electric plug into the socket.
4.
Push the water line into the guard tube (a) at the rear
of the appliance.
,
WARNING:
Be careful, otherwise people who are helping may
be injured or the appliance may be damaged.
The appliance may tip over while the water line is
pushing into the guard tube.
5.
To prevent the power cord from becoming caught,
tie a piece of string to the middle of the power cord
and feed forwards over the top of the appliance.
When pushing in the appliance, pull the cable
upwards. Take care not to pinch the power cord.
or
Using adhesive tape, tape the power cord to the
floor centrally behind the appliance approx.
15" (380 mm) away from the rear panel of
the installation enclosure.
6.
Carefully push the appliance into the installation
enclosure.
7.
Remove edge protection (if attached).
15
Publicité
