Bosch B30IB800SP Notice De Montage page 10

Required accessories and tools
Supplied accessories
Installation instructions

Operating instructions

Installation kit

Optional accessories
Heater Kit for Side-by-Side Installation XHEATHKIT10
If the gap between the appliances is less than 6" (160 mm).
Other required accessories
Ice maker installation kit
For connecting appliances which require water,
e.g. for an ice maker.
Other
Stepladder

Dolly, hand truck

Hammer drill for drilling holes in wall or floor

Bits according suitable for material and in different

sizes
Wooden beam (cross section min. 3" x 4") as an

alternative tip protection, length according to the
width of the installation enclosure
Wooden screws in different sizes

Thin plywood sheet, particle board or cardboard to

protect the floor from damage
Suitable material for covering and protecting

furniture (e.g. protective sheets)
Adhesive tape

Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
10
1
/ " OD copper line
4
Tools
Cordless screwdriver
Torx bit T20 and T30 +
magnetic holder
Torx screwdriver T20
5
/ " (8 mm) hex nut driver
16
Wood drills in different sizes
1
Open end wrench / "
2
(Width across flats 13 mm)
Multigrip pliers
Adjustable wrench
Cutter with adjustable blade
Metal tape measure,
folding rule
Square
Level, length 2' (60 cm) and
4' (1,2 m)