cecotec CONGA ROCKSTAR WET&DRY STEEL MAX Manuel D'instructions page 35

Cleaning the tank
1. Unlock the hooks and take out the main body and the high-efficiency filter or the one for
liquids.
2. Empty the tank.
3. Vacuum and shake the filters to remove any particle of dirt that may block them and
hinder proper air circulation. Avoid using the vacuum cleaner without the filter properly
assembled.
6. TROUBLESHOOTING
Before contacting our Customer Service, please check the following:
Problem
The motor does not start.
Suction power has
decreased.
Water comes out of the
blowing connector.
7. TECHNICAL SPECIFICATIONS
Model: Conga Rockstar Wet&Dry Steel Max
Reference: 08114
Voltage: 220- 240V~, 50/60Hz
Power: 1380 W
IP24
Technical specifications may change without prior notice to improve product quality.
Made in China | Designed in Spain
Possible cause
The power cord is not
plugged into a socket.
The power socket is
damaged.
The vacuum cleaner was not
switched on.
The appliance is obstructed.
It's necessary to change the
filter.
The filter for liquids is not in
place or the maximum tank
capacity has been exceeded.
Possible solution
Properly plug in the appliance.
Check that the socket is not
damaged.
Switch the appliance on.
Clear the obstruction.
Change the filter.
Unplug the power cord.
Put the filter back in place.
CONGA ROCKSTAR WET&DRY STEEL MAX
ENGLISH
35