cecotec CONGA ROCKSTAR WET&DRY STEEL MAX Manuel D'instructions page 34

ENGLISH
- Extensible tube
- Flexible tube
- 2-in-1 accessory
- Accessory for corners
3. ASSEMBLY
1. Attach the wheels to the base as shown in Figure 2.
2. Insert the high-efficiency filter if you want to vacuum solids or the filter for liquids you
want to vacuum liquids.
3. Place the main body on top of the tank and use the hooks on both sides to secure it in place.
Fig. 3
4. Insert the hose into the Wet&Dry or blowing connector and turn it clockwise to secure it.
Fig. 4
5. Choose the accessory you wish to use and attach it to the flexible hose connector.
4. OPERATION
Before switching on the appliance, make sure that the high-efficiency filter when vacuuming
solids or the filter for liquids when vacuuming liquids is properly installed.
1. Insert the end of the hose into the suction or blowing connector, depending on which you
wish to use. Make sure that the hose assembly is properly installed to ensure correct
operation of the appliance.
2. Connect the appliance to a mains socket and switch it on by pressing the on/off button.
3. Unplug the appliance after every use.
5. CLEANING AND MAINTENANCE
- Make sure the appliance is not plugged to a mains socket before cleaning it or carrying out
maintenance on it.
- Clean the tank, filters, and main body after every use.
- If the tank fills up during operation, empty it immediately so that it does not affect the
correct operation of the appliance.
- It is recommended to replace the filter after 30-50 hours of use (depending on how it is
used).
- If the appliance is not going to be used for a long period of time, it is recommended to store
it as described above, in a cool and dry place. Do not store it under direct sunlight or in
damp places.
34
CONGA ROCKSTAR WET&DRY STEEL MAX